Epson SC-T3100X Shift Printing

[Yavuz]

Hello
Epson SC-T3100X Printer is Shifting While Printing.
I always have to press on the same place. The machine was printing without any problems at first. Now it is shifting the print horizontally right and left inconsistently. I have two machines and both have the same problem. Windows 11 is installed on my computer. Why is the slide of the print?

[zedonet]

Is the print position on cut sheet paper not exactly at the same position may vary a bit to the left or to the right?
This is caused by the paper feed mechanism of the printer and cannot be fixed by the printer driver.
If you have a different problem, please let me know.

[Yavuz]

WhatsApp Image 2024-08-08 at 21.13.39 (1).jpeg (230.19 KiB) Viewed 10256 times

WhatsApp Image 2024-08-08 at 21.13.40 (2).jpeg (240.18 KiB) Viewed 10256 times

Epson Sc-T3100X I am converting the machine to a hard floor machine in this way. You can see our machine from the photos. Our machine prints glass. We draw a first template on the counter in the machine. Then we put glass on the drawn template and print. For this, the pressures must be at the same location.

Ekran görüntüsü 2024-08-08 212209.jpg (31.26 KiB) Viewed 10256 times

In the photo above, you can see that the machine does not print the circles in the same place during printing. How do we solve the problem of the machine not printing in the same place? This problem did not exist in the first prints. Later on, this problem started to occur.

[Yavuz]

Good day; In my last tests on print shifting, I sent the print from Photoshop and PrintFab.
The print I sent from Photoshop printed in the same place.
My print from PrintFab does not print in the same place.
How can we solve this problem?

[rocky]

Hello, if the prints from Photoshop are ok, make sure that the print settings on prinffab are the same, especially the size, I would look to see if there is no 'fit to page" options active somewhere, i'm no expert, just regular user, but as far as i know printfab does not change the size a all, i print films for screenprinting and all of them have registration marks and they fit perfectly, we're talking microns here, hope that you will solve the issues

[Yavuz]

Hello; Thank you for your answer. Print size does not change in PrintFab prints. The print prints horizontally 5-8 mm. sideways. This side printing can change to the right or left.