TurboPrint & PrintFab

We use our EPSON SC P900 to print out separions for screen printing art on film 13"x19"
Has been working fine for two years. Then all of sudden it's not working. Through print fab it looks like it goes to the spooler but then just sits there and won't go to printer when printer is 'Ready'
Not sure if settings were changed i didn't take a picture of settings when it was working.
Please help if you have any ideas?

Hello Billiewest,

if your printer is not responding at all, probably the print data does not reach the printer, e.g. because the network connection has changed. You could try to add your printer again in PrintFab (or modify the connection of the already set up print queue), and make sure that the chosen connection is correct. In case it is connected via network you could also if it works when connected via USB or vice versa.