TurboPrint & PrintFab

Just started using PrintFab Pro XL 1.22.

For a few days all was well. Then I started getting this "Head temperature sensor rank error". I've order a replacement print head, but wondering if there is something else that can cause this or a easier fix than replacing the head.

Hello, according to our experience this is a hardware problem in the print head that can be only solved by replacing the print head.

This is what I gathered too. I have a replacement printhead arriving tomorrow.

I replaced the Printer head, now I get Head ID error.

Is there anyway you can have the driver to ignore an error?

I got a second print head. But now when I try to Print, PrintFab displays a message that my trial period is over in 12 days, then closes. I won't print anything.

Uninstalled and Reinstalled Printfab. Now it prints after displaying the test period is about to end message. I added a custom page size of 13"x19" and trying to print to it. I now get this Error 1281.

According to the Canon status code manual, the error code 1281 means "Front output tray in upper position". Please check if the output tray is open.